RING ROLLER BENDER SECTION MACHINE MC550
- It's equipped with 9 standard rollers and washers by means of which you can still make all kinds of profiles. (Square pipe, rectangular, solid square bar, round and rectangular, U profile, T profile, angle, flat bar, edge flat bar,..)
- It is specially designed to carry out mass production through the control, which saves the position of the rollers in each curve to repeat the same operations later. Without longitudinal positioning control
- Three traction rollers, ideal and essential to bend round pipe, with smooth surface not to get the pipe or profile damaged
- Safe transmission between tempered planetary pinions by induction
- Tempered and rectified F-154 steel axles
- Electrohydraulic drive system
- Bend regulation independent of the lower rollers which allow much smaller bends in diameter and takes better advantage of the material than pyramid bending machines
- Electronically-controlled asymmetric roller position
- ESA S625 panel comes with the machine
- High precision digital radius gauge
| RING ROLLER BENDER SECTION MACHINE MC550 | Description |
| Max. bending capacity in round pipes | 4" inches or 101,6 mm |
| Diameter of the lower axles | 65 mm |
| Diameter of the upper axles | 80 mm |
| Net length of the axles | 130 mm |
| Outer roller diameter | 202 mm |
| Main motor | 3 KW / 4 CV. |
| Hydraulic motor unit | 0.75 KW /1 CV. |
| 3-phased voltage | 230/400 V |
| Adjustable roller speed | from 3 to 7 RPM |
| Measurement scope | From 55 to 11.250 millimeteres or from 2" to443" inches |
| Accuracy | 0.01 |
| Power supply | 3V CR2032 Lithium battery |
| Working temperature | 0 +/- 40ºC |
| Storage and transport temperature | -20ºC - 60ºC |
| Relative humidity | 80% |